Liquid Cooling Check Valve Product Structure Principle And Application

The water cooling Check Valve series is suitable for water supply and drainage pipes. The valve disc is guided by a central axis at both ends of the inlet, allowing for flexible opening and closing, and can be installed horizontally or vertically. The spring-loaded disc quickly closes, effectively eliminating water hammer, providing excellent sealing performance and silent closing. It boasts advantages such as small size, light weight, low fluid resistance, fatigue resistance, and long service life.

cooling water Check Valve Operating Principle:

1. The valve disc is guided by a central axis at both ends of the inlet and outlet, allowing for flexible opening and closing, and can be installed horizontally or vertically.

2. The spring-loaded disc quickly closes, effectively reducing water hammer pressure, providing excellent sealing performance and silent closing.

3. It boasts advantages such as small size, light weight, low fluid resistance, fatigue resistance, and long service life.

Structure and Application:

1. The valve body features a streamlined inner cavity designed for a 95% flow rate, eliminating sharp bends, corners, and protrusions, thereby reducing fluid resistance.

2. The disc features a tapered front and rear design, significantly reducing fluid resistance and noise caused by turbulent flow.

3. The disc's closing stroke is short, only 1/4 of the nominal diameter, reducing the disc's closing time and minimizing water hammer.

4. A spring accelerates the disc's closing speed, minimizing water hammer.

5. The disc's hollow, thin shell structure reduces its inertia, enabling quick actuation when closing and reducing the impact noise during closing.

6. It can be installed vertically, horizontally, tilted, or at any angle.

7. Compact structure, few parts, small size, light weight, and attractive appearance.

8. Both interior and exterior surfaces are sprayed with an environmentally friendly coating to ensure corrosion resistance and safety.

Check Valve cooling system Technical Parameters:

1. Nominal pressure: 1.0-1.6 MPa.

2. Nominal diameter: 40-600 mm.

3. Applicable media: Water and mildly corrosive fluids.

4. Applicable temperature: 0°C to +80°C.

5. Flange standards: GB/T 17241.6 and GB/T 9113.

6. Test standards: GB/T 13927 AP 1598.