Liquid Cooling Check Valve Product Structure Features And Applications

water cooling Check Valve is a cooling water Check Valve installed on the outlet pipe of a water pump specifically designed to prevent water hammer. When the pump is shut down, the Check Valve cooling system uses a spring to quickly close the disc when the forward flow rate approaches zero, effectively preventing water hammer and thus eliminating noise. The water cooling Check Valve also features a compact size, light weight, low fluid resistance, short structural length, fatigue resistance, and long service life. It is suitable for water supply and drainage, fire protection, and HVAC systems and can be installed at the pump outlet to prevent backflow and damage to the pump body.

Structural Features:

1. The Check Valve cooling body features a streamlined interior design, designed for 95% flow rate, eliminating sharp bends, corners, and protrusions, thereby reducing fluid resistance.

2. The disc features a tapered front and rear design, significantly reducing fluid resistance and noise caused by turbulent flow.

3. The disc's closing stroke is short, only 1/4 of the nominal diameter, reducing the disc's closing time and minimizing water hammer.

4. A spring accelerates the disc's closing speed, minimizing water hammer.

5. The disc's hollow, thin shell structure reduces its inertia, enabling quick actuation when closing and reducing the impact noise during closing.

6. This product can be installed vertically, horizontally, at an angle, or at any angle.

7. This product features a compact structure, few parts, minimal size, light weight, and an attractive appearance.

8. An environmentally friendly coating is applied to both interior and exterior surfaces to ensure corrosion resistance and safety.

Product Applications:

1. This cooling Check Valve is suitable for water supply and drainage pipelines. The disc is guided by a central axis at both ends of the inlet, allowing for flexible opening and closing, and can be installed horizontally or vertically.

2. The disc is spring-loaded, enabling quick closing to effectively eliminate water hammer, providing excellent sealing performance and silent closing.

3. It features advantages such as small size, light weight, low fluid resistance, fatigue resistance, and long service life.

Main Technical Parameters:

1. Nominal pressure: 1.0-1.6 MPa.

2. Nominal diameter: 40-600 mm.

3. Applicable media: Water and mildly corrosive fluids.

4. Applicable temperature: 0°C to +80°C.

5. Flange standards: GB/T 17241.6 and GB/T 9113.

6. Test standards: GB/T 13927 AP 1598.