Liquid Cooling Check Valve Product Applications And Technical Parameters

water cooling Check Valve is a valve installed on the outlet pipe of a water pump specifically designed to eliminate water hammer. When the pump is stopped, the cooling water Check Valve uses a spring to quickly close the disc when the forward flow rate approaches zero, effectively preventing water hammer and thus eliminating noise. The silent Check Valve cooling system also features a small size, light weight, low fluid resistance, short structural length, fatigue resistance, and long service life. It is suitable for use in water supply and drainage, fire protection, and HVAC systems and can be installed at the pump outlet to prevent backflow and damage to the pump.

Product Applications:

1. The silent water cooling Check Valve is suitable for water supply and drainage pipelines. The disc is guided by a central axis at both ends of the inlet, allowing for flexible opening and closing, and can be installed horizontally or vertically.

2. The disc is spring-loaded, enabling quick closing to effectively eliminate water hammer, providing excellent sealing performance and silent closing.

3. It features a small size, light weight, low fluid resistance, fatigue resistance, and long service life.

Structural Features:

1. The valve body features a streamlined interior designed for 99.9% flow, eliminating sharp bends, corners, and sharp protrusions, thereby reducing fluid resistance.

2. The disc features a tapered front and rear design, significantly reducing fluid resistance and noise caused by turbulence.

3. The disc's closing stroke is short, only 1/4 of the nominal diameter, shortening the disc's closing time and minimizing water hammer.

4. A spring accelerates the disc's closing speed, reducing water hammer.

5. The disc's hollow, thin shell structure reduces inertia, enabling quick actuation and reducing impact noise during closing.

6. This product can be installed vertically, horizontally, or at any angle.

7. This product features a compact structure, few parts, minimal size, light weight, and an attractive appearance.

8. Both interior and exterior surfaces are sprayed with an environmentally friendly coating to ensure corrosion resistance and safety.

Main Technical Parameters:

1. Nominal Pressure: 1.0-1.6 MPa.

2. Nominal Diameter: 40-600 mm.

3. Applicable Media: Water and mildly corrosive fluids.

4. Applicable Temperature: 0-80°C.

5. Flange Standard: GB/T 17241.6, GB/T 9113.

6. Test Standard: GB/T 13927 AP 1598.